Showing posts with label audio. Show all posts
Showing posts with label audio. Show all posts

Sunday, July 18, 2010

Simple FET Audio Mixer Circuit

This is a simple project circuit for mixes two or more channels into one channel (eg. stereo into mono). The circuit can mix as many or as few channels as you like and consume very little power. This is the figure of the circuit.


This circuit is based on or built by FET 2N3819. The circuit can be powered by a single 9 volt battery. As many or as few channels as are required can be added to the mixer. A shielded case is probably needed to reduce hum and help stop oscillations.

Part:
R1, R3 10K Pot
R2, R4 100K 1/4 W Resistor
R5 6.8K 1/4 W Resistor
C1, C2, C3 0.1uF Capacitor
Q1 2N3819 Junction FET
MISC Wire, Shielded (Metal) Case, Phone or Other Plug For Output

Simple Telephone Audio Interface

This is a simple design circuit for audio from a telephone line that can be obtained using a transformer and capacitor to isolate the line from external equipment. This is the figure of the circuit.


A non-polarized capacitor is placed in series with the transformer line connection to prevent DC current from flowing in the transformer winding which may prevent the line from returning to the on-hook state. The capacitor should have a voltage rating above the peak ring voltage of 90 volts plus the on-hook voltage of 48 volts, or 138 volts total. This was measured locally and may vary with location, a 400 volt or more rating is recommended. Audio level from the transformer is about 100 millivolts which can be connected to a high impedance amplifier or tape recorder input. The 3 transistor amplifier shown above can also be used. For overvoltage protection, two diodes are connected across the transformer secondary to limit the audio signal to 700 millivolts peak during the ringing signal. The diodes can be most any silicon type (1N400X / 1N4148 / 1N914 or other). The 620 ohm resistor serves to reduce loading of the line if the output is connected to a very low impedance.